How to Prepare for a Builders Clean
Quick answer Preparing for a builders clean means clearing the site so a detail crew can work once — not around leftover trades. Finish wet trades and major fit-out first, remove bulk rubbish and packaging, leave access power and water on, keep protective film where it still protects finishes, and send plans plus a few […]
When Should I Book a Builders Clean?
Quick answer Book a builders clean after wet trades, painting and major fit-out are largely finished, and close enough to inspection or practical completion that fine dust will not resettle from more trade work. Too early wastes the detail clean; too late risks a dusty handover or a rushed rebook. Builders, project managers and owners […]
Rough Clean vs Builders Clean: What’s the Difference?
Quick answer A rough clean is the mid-build clear-out of bulk rubbish and trade mess so finishing trades can work. A builders clean is the full post-construction clean once trades are largely done — dust, glass, joinery, fixtures — so the site is ready for inspection or handover. Most builds need both at different times. […]
Do I Need a Builders Clean After a Renovation?
Quick answer Yes — if your renovation involved demolition, plaster, tiling, painting or new joinery. Construction dust, grout haze, paint specks and silicone smears need a builders clean, not a domestic wipe. A paint-only refresh of one room may only need a thorough domestic clean. Lived-in homes also need adjacent rooms checked where dust has […]
What Is Included in a Builders Clean?
Quick answer A builders clean is a staged post-construction clean that gets a new build or renovation handover-ready. A full scope usually covers construction dust, floors, joinery, fixtures, bathrooms, kitchens and internal glass. It does not replace a bond clean, exterior pressure washing, or fixing defects. Rough clean and final clean are different stages — […]
What Does a Builders Clean Cost in Brisbane?
Quick answer A builders clean in Brisbane costs the same as anywhere else in Australia on a per-square-metre basis. Published 2026 industry ranges for a full handover clean including windows sit at roughly $8 to $12 per m², so a 250 m² project home typically lands around $2,000 to $2,400. Brisbane does not add a […]
Office Fit-Out Cleaning: What’s Different About a Commercial Handover
Quick answer A fit-out clean is a builders clean performed inside someone else’s operating building, against a date that can’t move. Three things drive it: building management rules (after-hours access, dock and lift bookings, inductions, waste routes), a fixed lease commencement date the tenant is already staffing towards, and two inspectors — the property manager […]
Practical Completion and the Final Clean: Why Cleaning Ends Up on the Defect List
Quick answer A builders clean on an apartment building isn’t a bigger version of a house clean. Four things change it: access and lift logistics, staged handover floor by floor, common areas that need their own scope, and keeping finished units clean while trades still work above them. Units are normally priced per unit at […]
Builders Clean for Apartments and Multi-Unit Developments
Quick answer A builders clean on an apartment building isn’t a bigger version of a house clean. Four things change it: access and lift logistics, staged handover floor by floor, common areas that need their own scope, and keeping finished units clean while trades still work above them. Units are normally priced per unit at […]
Silica Rules Change on 1 December 2026: What It Means for Your Handover Clean
Quick answer From 1 December 2026, Australia’s workplace exposure standards (WES) become workplace exposure limits (WEL). For respirable crystalline silica the number doesn’t move — it stays at 0.05 mg/m³ over an eight-hour average — but the wording change is deliberate: a limit is something you must not exceed, not a target to aim at. […]